HANGING BLOWING MODULS (FLOW MODUL)
|
|
The Flow Modul is a modular wall unit, with laminar flow and HEPA filter class H14.
It can be suspended from the ceiling or mounted on rails/legs for positioning on production lines or in areas where it is necessary to clean the area below.
Installation can be horizontal or vertical in relation to the product to be protected by laminar flow. |
|
|
- Functioning: to total recycling in the room
- Filtration: through H14 HEPA filter
- Filtration efficiency: 99,995% MPPS
- Chassis: stainless steel AISI 304 glazed scotch-Brite, thickness 1.5 mm (can also be supplied in galvanized sheet)
- Motor fan: radial and vertical axis
- Power: 270 Watt
- Noise level: < 60 dBA
- Flow rate: 0.40 m/sec
- Capacity: 1050 m3/h ca
- Dimensions:
° module 120: 1280 x 680 x 450 (h) mm
° module 180: 1890 x 680 x 450 (h) mm
- Useful dimensions of the aspirant surface:
° module 120: 1190 x 580 mm
° module 180: 1800 x 580 mm
- Weight (module in stainless steel):
° module 120: 100 Kg
° module 180: 150 Kg
- Weight (aluminum form):
° module 120: 85 Kg
° module 180: 130 Kg
CONTROL BOARD
Control board for control and protection, including:
- Filter net 10A
- Differential automatic switch magnetothermal modular of calibration appropriate to the number of protected modules (Max No. 4 devices protected by the same switch)
- Manual drive consists of an electronic card with manual rheostat located on the framework for a rapid adjustment of the rate of intake
- Hours run meter of fans; factory installation on the front of electrical panel with protective cover |
|
